PLANET UMG-1000 - Manual (Page 89)

89
Appendix A – Console Maintenance Mothod
The UMG-1000 Series has a built-in command line interpreter and provides users a
Command Line Interface (CLI). You can configure the network parameters by entering
commands from the CLI.
Please use the RJ-45 to RS-232 console cable that boundled in package. To connect the
RJ-45 port with Console port of UMG-1000, and connect another side (RS-232) with your
PC.
You can access the CLI from a VT-100 terminal or terminal emulator connected to the DB9
serial port or through a Telnet session. The UMG-1000’s serial port is EIA RS-232C
compliant with the interface parameters:
Baud rate
115,200
Number of data bits
8
Parity
None
Number of stop bits
1
Flow control No
To input the default account to login console mode: admin / admin
The bleow are the available command:
Command Description
Ifm get lan config To show the current LAN port network parameters
Ifm get wan config To show the current WAN port network parameters
Ifm set lan ip
To set the LAN IP address
For example:
ifm set la nip 192.168.1.1
system reboot To reboot system
System reset to default To reset the system to factory default
?
To show all of available command