PLANET HDVR-1600 - Manual (Page 9)

• For Non-DHCP users, set the DHCP to . IP address, Netmask, Gateway
and DNS settings must be set. Please obtain the information from the network
service provider.
• To change the IP address, Netmask, Gateway and DNS value, press UP/DOWN
keys to move the cursor to the item. Use LEFT/RIGHT keys to access each
section of the value and press ENTER, then change the value using UP/DOWN
keys.
• PPPoE users must set the , and
as well.
• When the settings are complete, press ENTER to confirm and save the settings;
or ESC to abort.
Dome Camera Control
Dome Camera Connection & Settings:
• See section Pin Definition of Alarm I/O & RS-485 for RS-485 port pin definition.
• Refer to the following figure. Connect the R+, R− terminals on the dome camera
to the D+, D− terminals on the RS-485 port by RS-485 cable respectively.
• To set up dome camera’s protocol and ID, press MENU to access the OSD main
menu, and select . The available protocols include ,
, , , , , C>, and . The default is . Note that ID number must
match the ID address defined by the dome camera.
• To configure the RS-485 parameters, select from OSD main
menu, and then select . The default RS-485 settings are ID
224, 9600 Baud, 8 Data Bits, 1 Stop Bit and No Parity.