PLANET DVR-1672 - Manual (Page 43)

37
5.7.2 HTTP Setup
Item Description
Enable HTTP Server Check to enable HTTP server. Users can remotely
access into the DVR over the network if the HTTP
function is activated.
Port Enter a valid port value from 1 up to 65535. The
default value is 80.
Quality and Frame Rate Setup for Network Transmission
No. Check to activate the transmission of each camera.
Quality
Choose from Below Basic / Basic/ Normal/ High/
Highest.
FPS Choose recording frame rate (1~30FPS).
Auto
The maximum recording frames available by the
average distribution of each channel (totally 60FPS).
This video streaming is used for network transmission; setting is LQ (low
quality). Under a low bandwidth capacity, this stream can send out small
picture and keep a good video quality and smooth display rate. If the
bandwidth is large enough, it can be adjusted to HQ (high quality). Thus, the
network streaming will be switched to the condition which this DVR is
recording. Therefore, a larger video image can be sent to remote site.