PLANET CAM-ISD52 - Manual (Page 9)

. .
User’s manual 8
4.1 DIP switches
Overview of DIP switches
There are three sets of DIP switch on board for different setup purposes.
location # bit quantity used for
DS1+DS2 (P1&2) 10 Device ID setup
DS2 (P3~P7) 5 Protocol / baud rate setup
DS3 2 Network impedance
Refer to the picture on below for DIP switch locations.
The following paragraphs are providing the detail descriptions of the three main
setups. Installer should read it with care, before starts doing the hardware mounting
and cabling work.
DS3
DS1 DS2