PLANET CAM-ISD52 - Manual (Page 8)

. .
User’s manual 7
4. Appearance
4.1 To Access DIP Switches
Before the camera is mounted in place, be sure the following four settings are
properly executed, or the camera may fail the control:
„
Camera ID setup
„
Protocol selection
„
Baud rate selection
„
Termination impedance
Tools:
Use pencil, pincer, paper clip or small flat screw driver, to move the lever of DIP
switch
Access points
:
The DIP switches are located on the bottom of the dome cameras:
DIP switches