PLANET IGT-1205AT - Manual (Page 21)

21
3.3 Wiring the Power Inputs
The 6-contact terminal block connector on the top panel of Industrial
Gigabit Media Converter is used for two DC redundant power inputs.
Please follow the steps below to insert the power wire.
1. Insert positive / negative DC power wires into contacts 1 and 2 for
POWER 1, or 5 and 6 for POWER 2.
1 2 3 4 5 6
Input DC 12~48V, AC 24V
V1- V1+ V2- V2+
PW
R1
Port 1 Port 2 Mode
Fault PW
R2
100FX 100FX
Redundant
1000X
ON
OFF
1000X Sw
itch
1 2 3
ON
V1- V1+ V2- V2+
Note
The above top panel is based on IGT-1205AT. The
6-contact terminal block connector is the same as that
of IGT-805AT. But the IGT-805AT does not provide 3 DIP
switches.
2. Tighten the wire-clamp screws for preventing the wires from loos-
ening.
1 2 3 4 5 6
Power 1 Fault Power 2
- + - +