PLANET IGT-1205AT - Manual (Page 20)

20
Step 5: Lightly pull out the bottom of the DIN-Rail from the track to
remove.
3.2.2 Wall-mount Plate Mounting
To install the Industrial Gigabit Media Converter on the wall, please
follow the instructions described below.
Step 1: Remove the DIN-Rail from the Industrial Gigabit Media
Converter; loosen the screws to remove the DIN-rail.
Step 2: Place the wall-mount plate on the rear panel of the Industrial
Gigabit Media Converter.
Step 3: Use the screws to screw the wall-mount plate on the
Industrial Gigabit Media Converter.
Step 4: Use the hook holes at the corners of the wall-mount plate to
hang the Industrial Gigabit Media Converter on the wall.
Step 5: To remove the wall-mount plate, reverse the steps above.