PLANET ICA-5250V - Manual (Page 64)

Motion Detection
IP CAMERA allows 3-area motion detection. When motion is
triggered, it can send the video to some specific mail addresses,
transmit the video to remote ftp server and SAMBA, and trigger
the relay. To set up the motion area, click “Area Setting” and use
mouse to drag and draw the area. The same operation is done
for areas 2 and 3.
Interval
For example, if you select "10 sec" here, once the motion is
detected and action is triggered, it cannot be triggered again
within 10 seconds.
Based on the
schedule
When the option box is ticked, only during the selected schedule
time the motion detection is enabled. That is, for example, the
11th hour of Monday has not been colored in the schedule table,
then no action will be triggered even the camera detects motion
during 11:00~12:00 on Monday.
Tampering Detection
If user enables this function and when anything covers LENS of
camera, it will send the video to some specific mail addresses,
transmit the video to remote ftp server and SAMBA, and trigger
the relay.
Record File Setting
IP CAMERA allows 3 different types of recording files to change
its record size. When motion/alarm is triggered, there are 3
different types of recording modes, and they are:
(1) AVI File (with Record File Setting )
(2)
. Multi-JPEG (with Record File Setting), only with JPEG
compression format.
(3) Single JPEG (Single File with Interval Setting)
Record Time Setting
Pre Alarm and Post Alarm setups for video start and end time
when motion detects I/O, or other devices got triggered.
Note: Pre/Post Alarm record time is based on record time setting
and IP cam built-in RAM memory. Limited by IP cam built-in
Ram memory and when information is too much or video quality
is set too high, it will cause recording frame to drop or decrease
post alarm recording time.
Network Disconnected
To avoid video loss, the camera will start to save the video to
local SD card when it detects no network connection. The
video recording will continuously be saved into SD card and
divided into every 10 minutes a file until the network is
reconnected successfully. The oldest file will be deleted if the
capacity of SD card is full.
Network IP Check
Key in the target IP address and interval. The camera checks
once in a while according to the setting interval time if it can link
to the target IP address. If connection fails, the camera starts to
save the video to SD card
5.4.2 Schedule
Schedule
After completing the scheduled setup, the camera data will be
recorded according to the scheduled setup.
64