PLANET ICA-4200V - Manual (Page 18)

Full HD 20M IR Vari-Focal Dome IP Camera
ICA-4200V
18
NOTE: Use the power adapter, 12VDC, included in the package and connect it to
wall outlet for AC power. And connect the other cables and connectors if
necessary.
6. When the camera cabling is completed, close the top cover dome housing and
secure it by two screws. And then adjust PIR sensor to proper position. Once the PIR
sensor is well [position, then secure it by another two screws.
6. Done
2.2.2. Network Installation
1. Connect an Ethernet cable
Connect the LAN cable on the camera to the network device (hub or switch).
NOTE: If there has an IEEE802.3af PoE switch in your network, you can connect the
camera LAN cable to this PoE switch to obtain power. The power adapter is
unnecessary when Internet camera is connected to a PoE switch.
2. Attach the power supply
Plug in power adapter and connect to power source. After power on, the camera will start to
operate.
NOTE: 1. Only use the power adapter supplied with Internet camera Otherwise, the
product may be damaged.
2. The power adapter is unnecessary when Internet camera is connected to a
PoE switch. Otherwise, the product may be damaged when Internet camera is
connected to a PoE switch and power adapter simultaneously.
3. Attach BNC connector
Connect the video BNC connector to a monitor set if necessary check camera viewing angle
and focus.