PLANET ICA-4200V - Manual (Page 16)

Full HD 20M IR Vari-Focal Dome IP Camera
ICA-4200V
16
RJ-45
(LAN socket, PoE )
Connect to PC or Hub/Switch.
For connect to 10Base-T Ethernet or 100Base-TX or 1000Base-TX Fast
Ethernet cabling. This Ethernet port built auto-negotiation protocol can
detect or negotiate the transmission speed of the network automatically.
Please use CAT-5 cable to connect the Network Camera to a 1000Mbps
Fast Ethernet network switch or hub.
Note：ONLY use one power source, either from DC or from 802.3af
Power over Ethernet.
12VDC in & Power
ND G
The input power is DC 12V, 1A.
Note：ONLY use package power adapter supplied with the internet.
Otherwise, the product may be damaged.
MIC in
(audio in)
Connect an external microphone to the camera.
Audio out +/-
Connect a loud speaker to the camera. This function is for voice alerting
and two-way audio.
Video out
Connect a TV monitor to the camera. User can check the focus/zoom
and view angle of the camera.
DI/GND/DO/RS485
The 6 pin terminal block includes 1 input ports and 1 output ports, and
RS-485 D+ and D-.
Factory Default
Reset
This button is used to restore the all factory default settings.
Restore the device:
a. Press the button down continuously.
b. Hold the button at least 5 seconds and release it. Then the device has
been restored to default settings and reboot again.
Micro SD Card Slot User can insert a micro SD card into this slot for recording.
NOTE: That to cabling this camera by type of connector board, firstly, user must
remove the attached “connector cable” from wafer 1~ 6 shown as below: