PLANET EPL-1000 - Manual (Page 34)

OLT Panel
The OLT panel is used to apply settings to OLT attributes. In some cases this may also
involve OAM transactions with ONUs. It should be noted that certain attributes of the OLT
such as SLAs are controlled via the Link Panel.
4.1 OLT Network Parameters
These commands allow the host to configure the way the PON will be managed.
OAM Rate
This command is used to view the default OAM rate
Loopback Timeout Value
This sets the loopback failsafe timer. If the operator sets a port in loopback mode the
loopback the OLT will initiate a count down timer for Loopback Timeout Value ms. When
the timer expires the loopback will automatically be canceled.
MPCP Parameters
„ Period
The interval at which the OLT will issue a discovery gate.
„ Window
The discovery window size in bytes.
VLAN Ethertype
This is the Ethertype value that the OLT will use to classify VLAN traffic (default = 0x8100)
- 34 -