Appendix b: error messages, Start-up error messages, Drive check error messages – Avago Technologies AcceleRAID 170LP User Manual
Page 49: Appendix b, Acceleraid 170lp error messages
Manual No. DB11-000024-00
B-1
Appendix B
AcceleRAID 170LP
Error Messages
☛
Note
The firmware you are using may have these messages
turned off. However, they are listed here for your
reference.
Start-up Error Messages
The BIOS looks for any initialization message posted by the firmware during
the start-up sequence. If a message is found, one of the following errors
displays on screen and the installation process aborts.
AcceleRAID 160 fatal error--Memory test failed!
AcceleRAID 160 fatal error--Command interface test failed!
AcceleRAID 160 hardware error--Run Diagnostics to pinpoint
error
AcceleRAID 160 firmware checksum error--Reload firmware
Drive Check Error Messages
If the firmware finds a valid controller configuration, but it doesn't match the
SCSI drives currently installed, one or more of the following messages
display. Then, the BIOS prints out the following:
AcceleRAID 160 Configuration Checksum error--Run
configuration utility!
If the firmware detects that during the last power cycle the system was turned
off abruptly leaving some incomplete write operations, the following
message appears:
Recovery from mirror race in progress
WARNING: Dead SCSI devices (Channel Target) : x:y
The following messages may also appear:
AcceleRAID 160
cannot recover from Mirror Race!
Some system drives are inconsistent!