Avago Technologies AcceleRAID 170LP - Manual (Page 24)

Installation Checklist
2-4 AcceleRAID 170LP Installation Guide
Installation Checklist
GET READY
☛
Note
It is recommended that you wear a grounded wrist
strap when performing hardware installation
procedures.
1. ____ Power off your computer system.
2. ____ Verify that you have the correct bracket installed on the controller.
3. ____ Remove the plate from the I/O access port to the PCI slot.
4. ____ Remove the AcceleRAID 170LP board from the anti-static bag.
GET SET
☛
Note
Review Figure 2-1, Figure 2-2, Figure 2-3,
Table 2-2, and Table 2-3 to get familiar with the
layout of the AcceleRAID 170LP controller board
and the Connectors, Jumpers, and LED descriptions.
5. ____ Plug the AcceleRAID 170LP board into a standard PCI slot.
6. ____ Secure the AcceleRAID 170LP board’s mounting bracket with a
screw or retainer.
7. ____ Connect the SCSI cable(s) from your drive(s) and/or device(s) to
the SCSI channel.
8. ____ Check SCSI termination for internal and/or external devices.
9. ____ Check disk drives. Be sure termination is set to the disabled
position on any disk drive(s) that will not be terminated. For
more information, see the documentation that accompanied the
disk drives.
10. ____ Set SCSI ID on the disk drive(s).
11. ____ Enable termination power on disk drive(s).
12. ____ Safety check the installation.
GO
13. ____ Go to Chapter 3, “Controller Board Start-up”.