Avago Technologies AcceleRAID 170LP - Manual (Page 22)

Before You Begin
2-2 AcceleRAID 170LP Installation Guide
Before You Begin
Installing the AcceleRAID 170LP single channel RAID controller is no
more difficult than installing any 32-bit PCI adapter card. The AcceleRAID
170LP single channel controller connects into any PCI 2.2 compliant slot on
the motherboard. Follow these steps and the installation procedures in this
chapter.
☛
Note
Recommended: Connect the AcceleRAID 170LP into
a 32-bit PCI slot to reserve the 64-bit PCI slot for
64-bit controllers.

WARNING
Working with the system covers off and power
applied to the system can result in shock and
serious injury.
1. Power off the system and disconnect the power cables before starting
the installation. Refer to the instructions provided in your system
documentation. Do not disconnect cables or power cords while system
power is on.
2. Check the size of the bracket installed on your controller. If necessary,
change the bracket to match your installation needs.
3. Read all of the instructions in this chapter completely before proceed-
ing. Follow the Notes, Cautions, and Warnings described in this manual
and marked on the equipment.
4. Follow electrostatic discharge (ESD) safety procedures. Use a
grounded wrist strap or ESD safe footwear, and work in an ESD safe
area.
5. Make sure all SCSI conventions (cable type, cable length, termination,
etc.) are followed, see Table 2-1.