beautypg.com

Avago Technologies MegaRAID SAS 0260CV-4i User Manual

Page 9

background image

LSI Corporation Confidential

|

July 2011

Page 9

MegaRAID SAS 9260CV-4i and SAS 9260CV-8i RAID Controller Quick Installation Guide

Installing the RAID Controller

a. Insert the controller into a PCI Express® slot on the motherboard, as shown in

Figure 4

.

b. Press down gently, but firmly, to seat the card correctly in the slot.

c. Secure the RAID controller to the computer chassis with the bracket screw.

NOTE: The MegaRAID SAS 9260CV-4i RAID controller and the MegaRAID SAS 9260CV-8i
RAID controller are PCI Express x8 cards and they can operate in x8 or x16 slots. However,
some PCIe slots support only PCIe graphics cards, and if you install a RAID controller, it
will not function. Refer to the guide for your motherboard for information about the
PCIe slot.

Figure 4: Installing the MegaRAID SAS 9260CV-8i RAID Controller

6. Configure and Install the SAS Devices, SATA II Devices, or Both in the Host

Computer Case

Refer to the documentation for the devices for any preinstallation configuration
requirements.

7. Connect the RAID Controller to the SAS Devices, SATA II Devices, or Both in the

Host Computer Case

Use SAS cables to connect the RAID controller to SAS devices, SATA II devices, or
both. See

Figure 2

to view the connector locations.

85081-04

Screw

PCI Socket

Edge of
Motherboard

Press
Here

Press
Here

T/N 221038 00135

T/N 221038 00135

S/N021038 00000140

S/N021038 00000140

This manual is related to the following products: