beautypg.com

Avago Technologies MegaRAID SAS 0260CV-4i User Manual

Page 5

background image

LSI Corporation Confidential

|

July 2011

Page 5

MegaRAID SAS 9260CV-4i and SAS 9260CV-8i RAID Controller Quick Installation Guide

Installing the RAID Controller

Turn off the computer, and unplug the power cords from the rear of the power
supply. Remove the cover from the computer.

3. Review the Jumpers and the Connectors

Figure 2

shows the location of the jumpers and the connectors on the RAID

controller. The jumpers are set at the factory, and you do not usually need to change
them.

NOTE: The SAS 9260CV-4i RAID controller does not contain the JT2B1 connector, which
supports ports 4–7. The SAS 9260CV-8i RAID controller contains the JT2B1 connector.

Figure 2: Layout of the MegaRAID SAS 9260CV-8i RAID Controller

Table 1

describes the jumpers and the connectors on the RAID controller.

NOTE: Pin 1 on the headers and connectors is highlighted in red in

Figure 2

.

Before you install the RAID controller, make sure that the computer is
disconnected from the power and from any networks.

!

CAUTION

85081-00

JT1A1

JT1A2

JT1A3

Ports 3-0

Ports 7-4

JT1A4

JT1B1

JT2B1

JT2B2

JT1B2

JT6A1
JT6A2
JT6A3

J5A1

This manual is related to the following products: