beautypg.com

Avago Technologies MegaRAID SAS 0260CV-4i User Manual

Page 7

background image

LSI Corporation Confidential

|

July 2011

Page 7

MegaRAID SAS 9260CV-4i and SAS 9260CV-8i RAID Controller Quick Installation Guide

Installing the RAID Controller

4. Connect the RAID Controller to the CVFM01

To connect the CVFM01 flash memory module on the RAID controller to a remote
CVPM01 unit, follow these steps.

a. Mount the CVFM01 unit to the chassis of your computer based on the location

and the type of mounting option.

JT2B1

x4 SAS Ports 7–4 Mini-SAS 4i internal
connector

NOTE: The SAS 9260CV-4i RAID
controller does not contain the
JT2B1 connector.

SFF-8087 x4 internal mini SAS connector

Connects the controller by cable to SAS
drives or SATA 2 drives.

JT2B2

x4 SAS Ports 3–0 Mini-SAS 4i internal
connector

SFF-8087 x4 internal mini SAS connector

Connects the controller by cable to SAS
drives or SATA 2 drives.

JT2B3

Standard edge card connector

The RAID controller interfaces with the
host system though a standard edge card.

This interface provides power to the
controller and an I

2

C interface connected

to the I

2

C bus for IPMI.

JT6A1

Global drive fault LED header

2-pin connector

Connects to an LED that indicates whether
a drive is in a fault condition.

JT6A2

Hard disk drive activity LED header

2-pin connector

Connects to an LED that indicates activity
on the drives connected to the controller.

JT6A3

Write pending LED header

2-pin connector

Connects to an LED that indicates when
the data in the cache has yet to be written
to the storage devices. Used when the
write-back feature is enabled.

Table 1:

Jumpers and Connectors (Continued)

Jumper/

Connector

Type

Description

JT6A1

a

k

+ve

-ve

JT6A2

+ve

a

k

-ve

JT6A3

a

k

+ve

-ve

This manual is related to the following products: