Chapter 2. installing your 3ware raid controller, Tools you need, Before you start – Avago Technologies 3ware 9650SE-12ML User Manual
Page 19: Tools you need before you start
www.3ware.com
15
Chapter 2. Installing
Your 3ware RAID
Controller
Tools You Need
You will need the following tools during installation:
An ESD grounding strap or mat
A Phillips screwdriver
Before You Start
3ware 9650SE RAID controllers can be installed in a standard
enclosure or in an enclosure with a backplane.
1
Be sure to read “Safety Information” on page 10 in Chapter 1.
2
If you have a Battery Backup Unit (BBU), install it on the
controller before proceeding. For details, see “Chapter 3.
Installing the Battery Backup Unit”.
3
If appropriate, set the PM2 (power management) jumper on the
disk drives, to enable staggered spinup. Check the
documentation that came with your disk drives to see whether
this is required.
4
SATA-2 hard drives are sometimes shipped from the
manufacturer with the transfer rate set to 1.5Gbps. If this is the
case for your drives, you may need to remove a jumper or run a
software utility to change the transfer rate to 3.0Gbps,. Please
check with your hard drive manufacturers documentation or
website on how to set the transfer rate to 3.0Gbps.