Avago Technologies SAS 9200-8e Host Bus Adapter - Manual (Page 19)

LSI Corporation
- 19 -
PCI Express to 6Gb/s Serial Attached SCSI (SAS) Host Bus Adapters User Guide
May 2013 Host Bus Adapter Characteristics
Characteristics of the LSI 6Gb/s HBAs
3.1.6.4 Physical Characteristics
The LSISAS9200-16e HBA is 8.2-in. × 4.2-in. The component height on the top and bottom of the LSISAS9200-16e HBA
is in accordance with the PCIe specifications.
Figure 7 LSISAS9200-16e Board Layout
 J10: PCIe x8-lane board edge connector
 J6, J7, J8, J9: SFF-8088 mini-SAS, external, right-angle connectors
 J4 and J5: 4-pin, right angle, 0.1-in. pitch pin header for driving external activity LED
 J3: UART connection
3.1.7 LSISAS9201-16e HBA Characteristics
The LSISAS9201-16e supports active copper cable and passive copper cable.
3.1.7.1 Memory
The LSISAS9201-16e HBA provides one 2-M × 16-bit Flash ROM for storing the firmware and BIOS, and provides
onboard DDR2 SDRAM.
3.1.7.2 LEDs
The LSISAS9201-16e HBA has two 4-pin headers for external connection of activity LEDs. The LEDs on header J3
correspond to activity on ports C and D, and header J4 corresponds to activity on ports A and B.
3.1.7.3 Connectors
This section describes the different connectors on the LSISAS9201-16e HBA. See Figure 8 for connector locations.
PCIe Connector (EC1). The LSISAS9201-16e HBA supports a x8 interface. The PCIe host interface connection is
through the edge connector, EC1, which provides connections on both the top (EC1B) and bottom (EC1A) of the
board. The signal definitions and pin numbers conform to the PCIe specifications.
SAS/SATA Connector (J6, J7, J8, J9). The LSISAS9201-16e HBA supports SAS connections through four external
connectors: J6, J7, J8, and J9, which are SFF-8088 mini-SAS, external, right-angle connectors.
J6
Port 3
J7
Port 2
J8
Port 1
J9
Port 0
J10
J4
J3
J5
LSISAS2016
3-00133-03