Avago Technologies SAS 9200-8e Host Bus Adapter - Manual (Page 11)

LSI Corporation
- 11 -
PCI Express to 6Gb/s Serial Attached SCSI (SAS) Host Bus Adapters User Guide
May 2013 Host Bus Adapter Characteristics
Characteristics of the LSI 6Gb/s HBAs
3.1.1.4 Physical Characteristics
The LSISAS9200-8e HBA is a 6.6-in. × 2.7-in., low-profile board. The component height on the top and bottom of the
LSISAS9200-8e HBA is in accordance with the PCIe specification.
Figure 2 LSISAS9200-8e Board Layout
 J7: PCIe x8-lane board edge connector
 J4, J5: SFF-8088 mini-SAS, external, right-angle connectors
 J3: 4-pin, right angle, 0.1-in. pitch pin header for driving external activity LED
 TP2: UART connection
3.1.2 LSISAS9210-8i HBA Characteristics
3.1.2.1 Memory
The LSISAS9210-8i HBA provides one 4-M × 8-bit Flash ROM for storing the firmware and BIOS. The LSISAS9210-8i HBA
can provide up to 32 K × 8-bit NVSRAM for storing nonvolatile RAID information when a system failure occurs.
3.1.2.2 LEDs
The LSISAS9210-8i HBA has a 4-pin header for connection of activity LEDs. The 4-pin header connects to two LEDs (see
Table 6 ), which indicate SAS activity on Port 0 and Port 1.
3.1.2.3 Connectors
This section describes the different connectors on the LSISAS9210-8i HBA. See Figure 3 for connector locations.
PCIe Connector (J6). The LSISAS9210-8i HBA supports a x8 interface. The PCIe host interface connection is through
the edge connector, J6, which provides connections on both the top (J6B) and bottom (J6A) of the board. The signal
definitions and pin numbers conform to the PCIe specification.
SAS/SATA Connectors (J4 and J5). The LSISAS9210-8i HBA supports SAS/SATA connections through connectors J4
and J5, which are SFF-8087 mini-SAS, internal, right-angle connectors.
LSISAS2008
J4
Port 1
J7
TP2
J3
3_00003-03
J5
Port 0