Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 29)

LSI Corporation
- 29 -
12Gb/s MegaRAID SAS RAID Controllers User Guide
April 2014
Chapter 3: MegaRAID SAS RAID Controller Characteristics
12GB/s MegaRAID SAS RAID Controller Family
The following table describes the jumpers and the connectors on the MegaRAID SAS 9361-8i RAID controller.
Table 5 Jumpers and Connectors
Jumper/
Connector
Type Description
J1A4
IPMI-style I
2
C connector for Ports 4 to 7
3-pin connector
Supports SCSI Enclosure Services (SES) over I
2
C through an internal I
2
C
backplane cable.
J1A5 Default Serial boot ROM (SBR) header 2-pin connector
Reserved for LSI use.
J1A6 Global drive fault LED header 2-pin connector
Connects to an LED that indicates activity on the drives connected to
the controller.
J1A7 Cache write pending header 2-pin connector.
Connector for an LED mounted on the system enclosure. The LED
indicates that the data in the cache has yet to be written to the
storage devices.
J1A9 On-board Serial Universal Asynchronous
Receiver/Transmitter (UART) connector 4-pin connector
Reserved for LSI use.
B
-$
YH YH
D N
B
-$
YH YH
D N