Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 10)

Avago Technologies
- 10 -
LSICVM01 Kit Quick Installation Guide
September 2014 Installing the LSICVM01 Kit
3.6 Reinstalling the RAID Controller on the Motherboard
Follow these steps to reinstall the RAID controller on the motherboard.
1. With the power to the chassis still turned off, and the power cords unplugged, make sure that the chassis is
grounded and has no AC power.
2. Install the RAID controller in a PCIe slot on the motherboard, as shown in the following figure.
NOTE Some PCIe slots support only PCIe graphics cards; a RAID controller
installed in one of these slots will not function. Refer to your computer
documentation for information about the PCIe slot.
3. Press down gently, but firmly, to seat the card correctly in the slot.
4. Secure the controller to the computer chassis with the bracket screw.
Figure 7 Reinstalling the MegaRAID Controller
Edge of
Motherboard
PCIe Slot
Bracket
Screw
Press
Here
Press
Here
3_00899-01