Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 9

Avago Technologies
- 9 -
CVFM03 and CVPM02 CacheVault Modules Quick Installation Guide
June 2015
Attaching a CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and
Connecting to a Remote CVPM02 Module
2.5
Connecting the CVFM03 Module to the Remote CVPM02 Module
Follow these steps to connect the CVFM03 module on the MegaRAID SAS 9265CV-8i RAID controller by cable to the
remote CVPM02 module on the remote mount board.
1.
Place the controller on a flat, clean, static-free surface.
2.
Ground yourself and make sure the system is grounded.
3.
Remove the cable included in the RAID controller box.
4.
Insert the cable connector on one end of the cable into the J2A1 cable connector on the CVFM03 module.
5.
Insert the other end of the cable into the cable connector for the remote CVPM02 module on the remote mount
board, as shown in the following figure.
Align the cable connectors to make sure they are connected correctly.
NOTE
You can insert the cable connector on the remote CVPM02 unit into
the larger 6-pin connector on the cable connector if the latch on the
cable connector aligns with the slot on the other cable connector. The
cable end inserts into the connector with minimal resistance.
Figure 5 Connecting the CVFM03 Module on the RAID Controller to the CVPM02 Module on the Remote Mount Board
3_00915-01
CacheVault
Power Module 02
(CVPM02)
Remote Mount
Board
J2A1
CacheVault
Flash Module 03
(CVFM03)