Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 11)

Avago Technologies
- 11 -
CVFM03 and CVPM02 CacheVault Modules Quick Installation Guide
June 2015 Attaching a CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and
Connecting to a Remote CVPM02 Module
2.7 Installing the Remote Mount Board in the System
Follow these steps to install the remote mount board in the system.
1. Make sure that the power to the chassis is still turned off, the power cords are unplugged, and the chassis is
grounded and has no AC power.
2. Insert the remote mount board in a PCI Express slot on the motherboard, as shown in the following figure.
NOTE Some PCI Express slots support only PCI Express graphics cards. If a
RAID controller is installed in one of these slots, the controller will not
function. Refer to your computer documentation for information
about the PCI Express slot.
3. Press down gently, but firmly, to seat the board correctly in the slot.
4. Use the bracket screw to secure the remote mount board to the computer chassis.
Figure 7 Installing the Remote Mount Board in the System
5. Reinstall the computer cover and reattach the power cords.
6. Turn on the power to the computer.
Refer to the MegaRAID SAS Software User Guide for information about running the RAID configuration utility and
installing the software drivers.
3_00918-01
Press
Here
Press
Here
Bracket
Screw
Remote Mount
Board
CacheVault
Flash Module 03
(CVFM03)
CacheVault
Power Module 02
(CVPM02)