Avago Technologies Cache Protection for RAID Controller Cards - Manual (Page 7)

Avago Technologies
- 7 -
CVFM03 and CVPM02 CacheVault Modules Quick Installation Guide
June 2015 Attaching a CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and
Connecting to a Remote CVPM02 Module
2.3 Installing the Clip Directly on the Remote Mount Board
Follow these steps to install the clip directly on the remote mount board.
1. Place the remote mount board on a flat, clean, static-free surface.
2. Ground yourself and make sure the system is grounded.
3. Remove the clip and the remote mount board module from the package.
4. Place the clip and the remote mount board module front-side-up on a flat, clean, static-free surface.
5. Hold the clip to line up the screw holes on the clip with the screw holes on the remote mount board, as shown in
the following figure.
Figure 3 Installing the Clip Directly on the Remote Mount Board
6. Secure the clip to the remote mount board in three screw holes with the screws and the nuts.
The screws thread through the front of the clip and the remote mount board.
7. Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten the screws.
A
A
A
Clip
3_00895b-00