Attaching the cvfm03 module, Directly to the raid controller – Avago Technologies Cache Protection for RAID Controller Cards User Manual
Page 6

Avago Technologies
- 6 -
CVFM03 and CVPM02 CacheVault Modules Quick Installation Guide
June 2015
Attaching a CVFM03 Module to a MegaRAID SAS 9265CV-8i RAID Controller and
Connecting to a Remote CVPM02 Module
2.2.2
Attaching the CVFM03 Module Directly to the RAID Controller
Follow these steps to attach the CVFM03 module directly to the RAID controller.
NOTE
There is danger of an explosion if the battery is incorrectly replaced.
Replace the battery only with the same or equivalent type
recommended by the manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
1.
Ground yourself, and make sure that the system is grounded.
2.
Remove the CVFM03 module from the package.
3.
Place the CVFM03 module front-side-up on a flat, clean, static-free surface.
4.
Place the RAID controller on a flat, clean, static-free surface.
5.
Install three screws into the board-to-board standoffs on the back of the controller, as shown in the following
figure.
6.
Hold the CVFM03 module so that the top side is facing upward, and align the J2M1 connector on the CVFM03
module with the J5B1 connector on the RAID controller.
Figure 2
Attaching the CVFM03 Module Directly to the RAID Controller
7.
Carefully press the CVFM03 module onto the RAID controller so that the two connectors are firmly joined.
8.
Secure the CVFM03 module to the RAID controller by installing the screws into the board-to-board standoffs
through the three screw holes in the CVFM03 module.
9.
Center the screwdriver carefully to avoid stripping the screw heads. Do not over-tighten the screws.
3_00914-00
CacheVault
Flash Module
(CVFM03)
J5B1