Check installation and close the case, Configure your sata+sas arrays – Avago Technologies 3ware SAS 9750-16i4e User Manual
Page 26
Chapter 2. Installing the 9750 SATA+SAS Controller Card
22
LSI 3ware 9750 SATA+SAS RAID Controller Card Installation Guide
Finishing Up the SATA+SAS Controller
Card Installation
After you have installed the controller in the computer and attached
appropriate cables to the controller and drives, complete the
following steps to complete the hardware installation.
Check Installation and Close the Case
1
Verify that the cables do not interfere with the operation of any
other components in the case or block the flow of cooling air.
2
Close the case and reconnect the power cables.
Configure Your SATA+SAS Arrays
Turn to “First Time RAID Configuration” and “Configuring Units”
in 3ware SAS/SATA RAID Controller Card Software User Guide,
Version 10.0 or newer for information about configuring RAID
arrays. The user guide is included on the 3ware CD that came with
your controller. It is also available from the LSI website at:
.