Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 20)

Chapter 2. Installing the 9750 SATA+SAS Controller Card
16 LSI 3ware 9750 SATA+SAS RAID Controller Card Installation Guide
8 Use the Phillips-head screws that are provided to secure the
iBBU07 to the RAID controller.
9 Install the RAID controller in a PCI Express slot in the
computer.
Connecting the iBBU07 Remotely to the 3ware 9750 Controller
Card
Use the supplied 20-pin cable to connect the iBBU07 to your RAID
controller.
Because server chassis design and workstation chassis design vary
from vendor to vendor, there is no standard mounting option that is
compatible with the various system configurations.
Therefore, the iBBU07 battery kit contains only the battery and the
cable, allowing value-added reseller’s (VAR) and chassis
manufacturers to customize the location of the remote battery to
provide the most flexibility within various environments.
Follow these steps to install the iBBU07 remotely to the RAID
controller.
1 Ground yourself, and remove the iBBU07 from the package.
2 Use the three Phillips-head screws that are provided to secure
the iBBU07 to the motherboard or the server chassis.
3 Insert the battery pack harness connector at the end of the
colored wires into the J4 connector on the rear side of the
iBBU07.
4 Connect one end of the 20-pin, 10-inch cable to the J2
connector on the iBBU07 and the other end to:
„ J4L1 connector on your 9750-4i and 9750-8i cards.
„ J6B1 connector on your 9750-4i4e and 9750-8e cards.
„ J1L1 connector on your 9750-16i4e and 9750-24i4e cards.
There are black triangles on the connectors to help you install
them properly. Insert the cable connectors so that the black
triangles are aligned.