Avago Technologies 3ware SAS 9750-16i4e - Manual (Page 19)

Before You Start
www.lsi.com/channel/products 15
Installing Your BBU
To connect your BBU directly or remotely to your 3ware 9750
RAID controller card see:
„ “Installing the iBBU07 Directly on the Your 3ware 9750
Controller Card”
„ “Connecting the iBBU07 Remotely to the 3ware 9750
Controller Card”
Installing the iBBU07 Directly on the Your 3ware 9750
Controller Card
Follow these steps to install the iBBU07 on the SAS 9750 RAID
controller. The battery backup unit is installed on the front side of
the controller.
1 Ground yourself, and remove the iBBU07 daughtercard from
the package.
2 Insert the battery pack harness connector at the end of the
colored wires into the 5-pin J4 connector on the backside of the
iBBU07.
3 Place the iBBU07 front-side-up on a flat, clean, static-free
surface.
4 With the front side up, place the RAID controller on a flat,
clean, static-free surface.
5 Hold the iBBU07 daughtercard so that the battery side is up and
the J5 connector lines up with the:
„ JT3B1 connector on the SAS 9750-4i and 9750-8i cards.
„ J6B2 connector on the SAS 9750-4i4e and 9750-8e cards.
6 Carefully press the iBBU07 onto the RAID controller so that
the two connectors are firmly joined.
7 Secure the iBBU07 to the RAID controller with the screws and
the standoffs in the three screwholes. The standoffs are
threaded at both ends, and a screw goes into each end.