Edirol V-44SW E1 - Manual (Page 43)

43
Registering Often-Used Settings (Panel Presets)
You can call up presets after you have started to fade out the
output.
1 Press the [MENU] button to display the Main menu.
2 Select “7. Panel Preset Edit” and select “4: Set Preset
Fade Time” from the sub-menu.
3 Set the fade time.
You can set the fade time to any value from 0.0 to 4.0
seconds.
You can elect to have only specified parameter settings in a
preset rather than all of the registered settings called up when
you call up the preset.
1 Press the [MENU] button to display the Main menu.
2 Select “7. Panel Preset Edit” and select “3: Preset Play
Select” from the sub-menu.
3 Set each parameter to “Free” or “Load.”
Free: The settings are not called up.
Load: The settings are called up.
You can copy a preset to a different PANEL PRESET button
and use that button for the preset.
• When the copy is executed, the settings originally
assigned to the copy-destination button are
overwritten and lost.
1 Press the [MENU] button to display the Main menu.
2 Select “7. Panel Preset Edit” and select “1: Copy”
from the sub-menu.
3 Select the preset to be copied and press the [ENTER]
button.
The preset shown at the left of the screen becomes the
copy source.
4 Select the preset copy destination and press the
[ENTER] button.
The message “Are You Sure?” appears.
5 Select “Yes” and press the [ENTER] button.
The preset is copied.
You can exchange the preset registered to one PANEL
PRESET with the preset registered to another PANEL
PRESET button.
1 Press the [MENU] button to display the Main menu.
2 Select “7. Panel Preset Edit” and select “2: Exchange”
from the sub-menu.
3 Select the preset to be exchanged and press the
[ENTER] button.
The preset shown at the left of the screen becomes the
exchange source.
4 Select the preset exchange destination and press the
[ENTER] button.
The message “Are You Sure?” appears.
5 Select “Yes” and press the [ENTER] button.
The presets are exchanged.
Fading Out the Output When Calling Up Presets
Specifying the Parameters To Be Called Up
with Presets
7. Panel Preset Edit Preset → Play Select Sub Menu
1: Output Fade Output Fade Mode,
OUTPUT FADE Level settings
2: Input Channel select button settings
3: P in P Picture in Picture settings
4: Key Key Composite settings
5: Transition TRANSITION select button settings
6: Preset Play Reset The sub-menu settings are returned to
their factory default settings (
☞ p. 29).
Copying Presets
Exchanging Presets Between
PANEL PRESET Buttons
V-44SW_e.book 43 ページ ２００６年１０月２３日 月曜日 午後３時２５分