SAF-HOLLAND XL-AS11406OM CBX/CB Series Fixed Frame Top Mount Trailer Air Suspension - Manual (Page 5)

5 XL-AS11406OM-en-US Rev B · 2012-06-29 · Amendments and errors reserved. © SAF-HOLLAND, Inc.
Decal Requirements
2. Standard Decal Requirements
The following three (3) decals must be properly installed on
the trailer prior to putting it in service:
t5JSF$MFBSBODF8BSOJOH%FDBM9-"3(Figure 1).
t4XJOH"MJHO ™ Axle Alignment Decal: XL-AR372-01 (Figure 2).
t5PSRVF%FDBM9-"3(Figure 3).
Figure 1
WARNING
Minimum tire clearance MUST be maintained between tires and
nearest point of contact on the suspension or vehicle. Premature
tire wear, fire or loss of vehicle control could result from contact
with the tires if clearances are not maintained.
XL-AR356-01
TIRE CLEARANCE REQUIREMENTS
1 INCH (25.4 mm) MINIMUM VERTICAL
feature.
2 INCH (50.8 mm) MINIMUM LATERAL
Axle.
www.safholland.us Copyright © 2011 #SAF-HOLLAND, Inc.
Figure 2
Figure 3
ALIGNMENT BOLT IS ON THE FRONT OF THE ROADSIDE FRAME BRACKET:
XL-AR372-01
STEP 1. Before aligning axle, pull trailer forward in a straight line for a sufficient distance to insure there are no binds
in the suspension and then lock the brakes so the slider lock pins rest against the rear of the body rail holes.
STEP 2. Check to verify trailer is empty and emergency brakes are NOT engaged.
STEP 3. Rotate bolt CLOCKWISE to move axle forward (A arrows); COUNTERCLOCKWISE to move axle rearward (B arrows).
A = axle forward
B = axle rearward
ALIGNMENT BOLT HEAD
NOTE: 1/2 turn of
free play in either
direction (A or B)
is acceptable.
SWINGALIGN ™ NON-WELDED AXLE ALIGNMENT PROCEDURES
www.safholland.us Copyright © 2011 #SAF-HOLLAND, Inc.
It is the responsibility of the end user to periodically inspect
all decals and ensure that they are clean and completely legible.
If any decals are missing, loose, damaged or difficult to read,
contact SAF-HOLLAND Customer Service at 888-396-6501 to
order replacements immediately.
Torques are with clean, lubricated threads.
Always apply torque to nut, if possible.
REQUIRED RE-TORQUING SCHEDULE:
miles.
maintenance.
relining.
Fastener Size
Pivot Connection Shock Air Spring SwingAlign
1-1/8" 3/4" 1/2" 3/4" 1/2"
Torque
Ft.-Lbs.
-#
450-500
(608 - 676
140-175
(190-
30-40
(41-
40-45
(54 -
50-60
(68 -
CBX / CB FIXED FRAME TRAILER AIR SUSPENSION TORQUE SPECIFICATIONS
XL-AR436 www.safholland.us Copyright © 2012 -SAF-HOLLAND, Inc.