KEPCO MAT Full Rack MAT 6V, 15V, 25V AND 36V MODELS - Manual (Page 19)

2-2
MAT 6V/15V/25V/36V/ 041807
FIGURE 2-1. FRONT VIEW OF THE FULL RACK MAT POWER SUPPLY
TABLE 2-2. FRONT CONTROL MAT POWER MODULE
ITEM NO.
(See Fig. 2-1)
CONTROL FUNCTION
1 AC POWER Switch/circuit Breaker Serves as an AC power switch and turns the AC power
line off on overvoltage, overcurrent, overtemperature or
power loss. CAUTION: DO NOT repeatedly toggle the
circuit breaker/switch as this may cause unit to fault.
Set Power ON/OFF circuit breaker/switch on front panel
to ON. If actuator does not lock when released, wait a
few seconds before trying again. The circuit breaker is
"trip-free" design; if overload exists or the protection is
activated, contacts cannot be held closed by actuator.
2 VOLTAGE MODE indicator, green LED Energized in voltage mode.
3 CURRENT MODE Indicator, Yellow LED Energized in current mode.
4 VOLTAGE/CURRENT Meter with selection
switch, green LED/ yellow LED Green LED energizes when meter reads output voltage.
Yellow LED energizes when meter reads output current.
5 OUTPUT ENABLED Indicator, green LED Energized when relay closes and voltage is present at
the power module output terminals.
6 POLARITY REVERSED Indicator, green LED Energized when relay closes and polarity at power mod-
ule output terminals is reversed.