Subaru Robin EH72 FI - Manual (Page 15)

9
5. OPERATING YOUR ENGINE
STARTING
NOTE
Following operating method is for
the STD type speed control lever.
As to the fixed type speed control
lever (exp. Generator spec.), do
not move it otherwise the
generator component such as
voltage regulator may be
damaged.
If there is a control box mounted,
turn the key switch and set it to the
"RUN" position. Check to make
sure that the warning and other
lights illuminate (red).
When the key switch is set to the
drive position (RUN) the operating
noise of the fuel pump may be
audible for two or three seconds
(this is not a malfunction).
ELECTRIC STARTER
1
(Provided by the equipment
manufacturer)
Open the fuel valve.
Set the speed control lever 1/3 of
the way towards the high speed
position.
FUEL VALVE
SPEED CONTROL LEVER
Turn the key switch to the "START"
position.
Do not operate the electric starter
continuously for more than 5
seconds, even if the engine dose not
start.
If the engine failed to start, set the
key to the "RUN" position and wait for
about 10 seconds before retrying.
Never turn the key switch to the
"START" position while engine is
running.
ELECTRIC STARTER
4
2
RUN
WARNING
LAMP
(Light up)
OFF
RUN
START
3
START
OFF
RUN
START