TA Triumph-Adler CX 8682 - Manual (Page 29)

CHAPTER 4 BASIC COPYING
4-5
1
2
3
4
(Inch)
(Metric)
(Inch)
(Metric)
(Metric) (Inch)
4. Paper Material Selection
If the Media key is pressed, the paper material to be used can be
selected from “Plain” [“Bond paper”], “Vellum ”, “Film”, and “Custom ”.
If the paper material is selected, fixing temperature and copy size will
be automatically adjusted.
If “Custom” is selected, paper material, fixing temperature, and copy
size that have been set by using “
@ Custom paper adj.” [“Custom
paper material adj.”] of the default setting will be selected. (Page 7-3)
If “
2 Paper working” of the default setting is set to “ON”, the paper
material installed in each paper source can be registered. If the Paper
Source key is pressed to select a paper source, the paper material
setting will be automatically changed. See “
2 Paper working” and “ 3
Paper material adjustment ” of the default setting. (Page 7-1)
Press the Media key.
Press the ▼ or ▲ key to select the paper material to be
used.
Select the material from “Plain” [“Bond paper”], “Vellum”,
“Film”, and “Custom”.
Press the OK key.
Check that the selected paper material is displayed in the
message display.
When the paper material is changed, wait until the fixing
temperature is stabilized. Scanning of an original, however,
can be performed.
➔
➔