TA Triumph-Adler CX 8682 - Manual (Page 26)

CHAPTER 4 BASIC COPYING
4-2
1 4
2
3
5
6
2. Basic Copying
1. Turn the main power switch on.
Turn the main power switch on(
❘ ). The machine will warm up for
approximately 360 seconds.
When the message “Ready to scan.” appears in the message display,
scanning of originals or copy function setting can be performed.
When “Ready to copy.” appears, copying can be performed.
* When turning on and off the main power switch repeatedly, be sure
to turn on and off at an interval of more than 1 second. If the interval
is less than 1 second, the machine may not start normally.
2. Select the desired copy mode. (Page 4-4)
Press the APS/AMS key to select the APS mode or the AMS mode.
3. Select the desired paper source.
Press the Paper Source key to select the desired paper source.
A number indicating a paper source will be displayed in the message
display.
When the bypass is selected, the margin copy, border erase, APS,
and AMS functions cannot be used.
4. Select the paper material. (Page 4-5)
Press the Media key to select the desired paper material. The paper
material can be selected from “Plain”, “Vellum”, “Film”, and “Custom”.
5. Select the cut length. (Page 4-6)
Press the Cut Size key to select the desired cut method. The method
can be selected from “Synchronized cut” [“Synchronized”], “Standard
cut” [“Standard size”], and “# keys”.
6. Select the original contrast.
Press the Original Image Type key. Press the tor
▲▼ key to select the
type of the original. To return to the basic screen, press the OK key.
“Normal original”: Standard originals such as drawings and newspa-
pers. When using the carrier sheet, select this
mode.
“Text”: Select this mode when using originals containing both text and
line drawing.
“Photo”: Select this mode when using originals such as photos and
posters.