Rose Electronics ServeView Pro - Manual (Page 26)

SAFETY
SERVEVIEW PRO INSTALLATION AND OPERATIONS MANUAL 22
Safety
This ServeView Pro KVM switch has been tested for conformance to safety
regulations and requirements, and has been certified for international use.
Like all electronic equipment, the ServeView Pro should be used with care.
To protect yourself from possible injury and to minimize the risk of damage
to this Unit, read and follow these safety instructions.
 Follow all instructions and warnings marked on this Unit.
 Except where explained in this manual, do not attempt to service this
Unit yourself.
 Do not use this Unit near water.
 Assure that the placement of this Unit is on a stable surface or rack
mounted.
 Provide proper ventilation and air circulation.
 Keep power cord and connection cables clear of obstructions that
might cause damage to them.
 Use only power cords, power transformer and connection cables
designed for this Unit.
 Use only a grounded (three-wire) electrical outlet.
 Keep objects that might damage this Unit and liquids that may spill,
clear from this Unit. Liquids and foreign objects might come in contact
with voltage points that could create a risk of fire or electrical shock.
 Operate this unit only when the cover is in place.
 Do not use liquid or aerosol cleaners to clean this Unit. Always unplug
this Unit from its electrical outlet before cleaning.
 Unplug this Unit from the electrical outlet and refer servicing to a
qualified service center if any of the following conditions occur:
 The power cord or connection cables is damaged or frayed.
 The Unit has been exposed to any liquids.
 The Unit does not operate normally when all operating
instructions have been followed.
 The Unit has been dropped or the case has been damaged.
 The Unit exhibits a distinct change in performance, indicating
a need for service.