RIGOL MSO/DS1000Z Series - Manual (Page 52)

RIGOL
4 MSO1000Z/DS1000Z Quick Guide
Power-on Inspection
When the oscilloscope is energized, press the power key
at the lower-left corner
of the front panel to turn on the oscilloscope. During the start-up process, the
oscilloscope performs a series of self-test items. After the self-test is finished, the
welcome screen is displayed. The instrument is installed with the trial versions of the
options before leaving factory and the remaining time is about 2000 minutes. The
"Installed Options" dialog box will be displayed if your instrument currently installs
the trial versions of options. From this dialog box you can view the name, detail,
version and remaining trial time of the option currently installed.
To Connect the Probe
RIGOL provides passive probe (standard) for DS1000Z series as well as passive
probe (standard) and logic probe (standard) for MSO1000Z series. For detailed
technical information of the probes, please refer to corresponding Probe User’s Guide.
The following are the probes recommended for use with the oscilloscope.
Model Description
RP2200A 150 MHz, passive probe, standard
RPL1116 Logic probe, standard
Connect the Probe:
1. Connect the BNC terminal of the probe to an analog channel input of the
oscilloscope at the front panel.
2. Connect the ground alligator clip of the probe to the circuit ground terminal and
then connect the probe tip to the circuit point under test.
Figure 5 To Connect the Passive Probe