RIGOL DS6000 Series - Manual (Page 54)

RIGOL
DS6000 Quick Guide 4
To Connect to AC Power Supply
This oscilloscope accepts two kinds of AC power supply: 100-127V, 45-440Hz or
100-240V, 45-65Hz. Please use the power cord supplied with the accessories to
connect the oscilloscope to the power source as shown in the figure below. After the
power switch under the power plug is turned on, the oscilloscope is energized and
the power key
at the lower-left corner of the front panel is in breath state.
Figure 5 To Connect to AC Power Supply
CAUTION
If the power fuse needs to be changed, please return the instrument back
to our factory and the
RIGOL authorized operator will change it for you.
To Use the Battery
This oscilloscope also provides rechargeable battery on your option. Please install the
battery as shown in the figure below. When leaving the factory, the battery holds
certain electric quantity. When use the battery only, a battery icon
will be
displayed at the lower-right corner of the screen and the remaining electric quantity
is indicated (no display when the AC power and battery are used at the same time).
When the electric quantity of the battery is too low, a message box would pop up
indicating “Low Battery!”.
If recharge is needed, please install the battery correctly and then follow the “To
Connect to AC Power Supply” instruction to connect the oscilloscope to AC power
supply to recharge the battery. It needs about 15 hours for the battery to finish
recharging.