beautypg.com

Certifications and compliances – RIGOL DS6000 Series User Manual

Page 42

background image

RIGOL

10

RP1002C User’s Guide

Certifications and Compliances

EC Declaration of

Conformity – Low

Voltage

Low Voltage Directive 73/23/EEC, as amended by

93/68/EEC

Low Voltage Directive 73/23/EEC, as amended by

93/68/EEC

EN 61010-1/A2:1995:

Safety requirements for

electrical equipment for measurement, control and

laboratory use - Part 1: General requirements

.

EN 61010-2-032:1995:

Safety requirements for

electrical equipment for measurement, control and

laboratory use - Part 2-032: Particular requirements

for hand-held current clamps for electrical

measurement and test.

Additional

Compliance

IEC61010-1/A2:1995:

Safety requirements for

electrical equipment for measurement, control and

laboratory use - Part 1: General requirements

.

IEC61010-2-032:1994:

Safety requirements for

electrical equipment for measurement, control, and

laboratory use - Part 2-032: Particular requirements

for hand-held current clamps for electrical

measurement and test.

Installation

(Overvoltage)

Category

CAT III: Equipment in a fixed industrial location

(usually permanently connected)

CAT II: Equipment at this level includes appliances,

portable tools, and similar products. Equipment is

usually cord-connected.

CAT I: Secondary (signal level) or battery operated

circuits of electronic equipment.

Pollution Degree

A measure of the contaminates that could occur in

the environment around and within a product.

Products should be used only in the environment for

which they are rated.

Pollution Degree 1:

No pollution or only dry, nonconductive pollution

occurs. Products in this category are generally

encapsulated, hermetically sealed, or located in clean

rooms.

Pollution Degree 2:

Normally only dry, nonconductive pollution occurs.

Occasionally a temporary conductivity that is caused

by condensation must be expected. This location is a

typical office/home environment. Temporary

condensation occurs only when the product is out of

service.

This manual is related to the following products: