RIGOL DS6000 Series - Manual (Page 38)

RIGOL
6 RP1002C User’s Guide
To Install the Battery
1 Remove the test clamp from the circuit.
2 Remove the three screws on the rear cover and take off the
rear cover. You can see the location of the battery and remove
the battery.
3 While observing polarity, install the new alkaline battery at the
corresponding location.
4 Install the rear cover.
AC Power Adapter
1 The specified AC power adapter can be used to avoid
measurement error due to poor battery durability.
2 When using an AC power adapter for an extended time, you
are recommended to remove the battery. This is because
heating will result in battery leakage, and battery electrolyte
will rust the circuit board, thus creating major damage.
Furthermore, as batteries are high pollution products, you are
recommended to avoid using them as far as possible.