Umbilical for connecting fan and dm32 gauge, 10 to 2.5 (250 to 63 mm) inch adapter, Adapters – Retrotec Commercial 441 and 451 DucTester User Manual
Page 16: Toolbag keeps all testing components in one place, Tubing accessory kit
Page 16 of 56
©Retrotec Inc. 2015
3.4.2.
Umbilical for connecting fan and DM32 gauge
An umbilical neatly bundles the needed pressure tubes and Control Cable, to prevent
the user from being greeted by a tangled mess of tubes and cables before each test.
The standard 7 foot (2m) long DucTester umbilical includes a yellow, green, and blue
pressure tube, as well as the Control Cable used for the DM32 to communicate with
the fan.
3.4.3.
10 to 2.5 (250 to 63 mm) inch adapter
The Flange is the intermediate part used to secure the Flex Duct onto a return
register by using masking tape or Grill Mask. For instructions on how the Flange is
connected, refer to section Error! Reference source not found..
3.4.4.
Adapters.
Adapters included begin with a 100 to 100 mm metal collar.
3.4.5.
Toolbag keeps all testing components in one place
The Deluxe Cordura Tool bag provides enough volume to hold all the system
components of a DucTester System. It includes a shoulder strap for easy carrying.
The vented exterior pocket is an important feature, useful for storing your smoke
puffer which will destroy your gauge and laptop if stored together.
3.4.6.
Tubing Accessory Kit
The Tubing Accessory Kit comes with blue, red, yellow and green pressure
tubes approximately 37 ft each, 1/8” inner diameter (11 m each, 3 mm ID), four
short male-to-male pressure tube connectors, two T-connectors for pressure
tubes, a Static Pressure Probe, and a metal tube. Attaching a Static Pressure
Probe to the pressure tube can prevent pressure reading interferences from wind or other air flows
blowing on the pressure tube. The metal tube can be passed through a small such as under a door or
window to prevent the tube from being pinched, and affecting the pressure reading.
For parts, look at:
http://retrotec.com/products/accessories-parts
.....................................................................................all on the Retrotec website
For more information on these parts, contact: