Precision Digital PD663 - Manual (Page 29)

PD663 Loop-Powered Meter Instruction Manual
29
Reset Meter to Factory Defaults
When the parameters have been changed in a way that is difficult to determine
what’s happening, it might be better to start the setup process from the factory
defaults.
Instructions to load factory defaults:
Enter the Advanced features menu. See Advanced Features Menu, page 23.
Press Up arrow button to display info menu.
Press Right arrow button when info is shown.
Press Enter button when rSt is shown.
Press Enter again when display flashes rSt.
Note: If Enter is not pressed a second time within three seconds, rSt will stop
flashing and the last Enter press cancelled.
The meter goes through an initialization sequence (same as on power-up), and
loads the factory default settings.
rSt info
Press and Hold for 5 Sec
Meter Re-
Initializes
Flashing
Display
rSt
FNc