Epson EQUITY Y14499113001 - Manual (Page 20)

To connect your printer to a parallel interface:
1. Place the printer in a convenient location next to your system, as shown
in Figure 1-9 for example.
2.
3.
4.
Figure 1-9. Locating the printer
Before connecting any cables, make sure the power switches on both the
main unit and the monitor are switched off, If you are not sure which
cable you need, consult your dealer.
One end of the printer cable has a 25-pin male D-connector. (Refer to
your printer manual to determine which end this is.) Connect this end
to the socket marked
PARALLEL
on the back panel of the main unit. If
the plug has retaining screws, tighten them with a small screwdriver.
Connect the other end of the cable to the printer. To secure the cable,
tighten the squeeze locks at each side of the printer port and into the
connectors on each side of the cable as shown in Figure 1-10.
1-11