Installation and assembly – MCZ Swing HYDRO User Manual
Page 26
DX1
f
f
24
4-INSTALLATION AND ASSEMBLY
BOTTOM SIDE PANEL
In the case shown in the figure, take the panel marked with code DX1:
•
the hole on the panel's bracket must go inside the hooks of the brackets located on the stove's base
•
fit in the upper hooks
•
check the alignment of the ceramic part with the door
•
tighten the screws in the brackets at the bottom and the top
•
position no.2 felt pads at the top of the ceramic part (pos.f) to prevent damage to ceramic parts that touch each other
Caution! Tighten the screws of the upper brackets so that it is positioned vertically. This is done to facilitate the
alignment with the intermediate ceramic part.
BOTTOM PANEL POSITIONING