Installation and assembly – MCZ Boxtherm 60 Pellet User Manual

Page 26

Pellet

3-INSTALLATION AND ASSEMBLY

It is extremely important to make sure the product is not immediately overheated and the temperature is increased gradually, initially

using low power.

This will prevent damaging the welds and the steel structure.

DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!!

LOADING THE PELLETS

Fuel is loaded from the front tray above the door. The loading procedure is facilitated if performed in several steps as described below:

• open the tray with the supplied cold handle. The guides of the tray have an end-of-travel that block the mobile part when extracted

completely. The tray is blocked in place when fully extracted by lifting it slightly and pulling it towards you.

• Pour the pellets into the tray directly from the bag or using the supplied scoop (A).

• Push the pellets towards the hopper using the supplied tool (B).

No other type of fuel other then pellets, in compliance with above-mentioned specifications, is to be inserted into

the hopper.

SPADE A

TOOL B

This manual is related to the following products: