Epson DLQ-3500 - Manual (Page 28)

Micro Adjust Function (3/4)
EPSON DLQ-3500 Quick Guide
Micro Adjust Function
The Micro Adjust function allows you to
move the paper forward or backward in
0.141 mm (1/180-inch) increments so
that you can make precise adjustments
to the top-of-form and tear-off positions.
Adjusting the tear-off position
If your paper perforation is not aligned with
the tear-off edge, you can use the Micro
Adjust function to move the perforation to
the tear-off position.
Follow these steps to adjust the tear-off
position:
c
Caution:
Never use the knob to adjust the tear-off
position; this may damage the printer or
cause it to lose the tear-off position.
Note:
Your tear-off position setting remains in effect
until you change it, even if you turn off the
printer.
1. Press the Pause button if the printer is
printing.
2. Make sure the Tear Off/Special Paper
lights are flashing (the paper is at the
current tear-off position). You may need
to press the Tear Off/Special Paper
button to advance the paper to the
tear-off position.
3. Hold down the Pause button for about
three seconds. The Pause light begins
flashing and the printer enters the Micro
Adjust mode.
4. Press the LF/FF
D button to feed paper
backward, or press the Load/Eject U
button to feed paper forward, until the
paper perforation is aligned with the
tear-off edge of the printer cover.
Note:
The printer has a minimum and a maximum
tear-off position. If you try to adjust the
tear-off position beyond these limits, the
printer beeps and stops moving the paper.
5. Tear off the printed pages.
6. Press the Pause button to exit the Micro
Adjust mode.
When you resume printing, the printer
automatically feeds the paper back to the
top-of-form position and begins printing.
Paper Out Pause
3sec
Micro Adjust
LF/FF Load/Eject