Ericsson A1018 - Manual (Page 31)

Not
f
or Com
mercial
Use
E
ri
cs
s
on M
obile Com
m
unicat
ions
A
B
30 Personalizing Your Phone
You can choose the type of ring signal from a list of different sounds
and melodies. You can also compose a melody of your own by enter-
ing notes with the keypad (see “Your Own Ring Signal” on page 30).
To choose one of the ring signal types
1. Scroll to Settings , Y E S , Ring type , Y E S , Phone , Y E S .
2. Scroll until you find the ring signal type that you want.
3. When you reach the ring type you want, select it by pressing
Y E S .
Different Ring Signals for Line 1 and Line 2
If you subscribe to the Alternate Line Service (ALS), L1 or L2 ,
depending on the line in use, is displayed instead of Phone. This
means that you can set different ring signals for the two lines.
Different Ring Signals for Speech, Data and Fax Calls
If you have turned the Data menus on (see “Sending and Receiving
Faxes” on page 65), you can set different ring signals for speech (the
display shows
Phone , L1 or L2 ), fax and data calls respectively.
You can compose your own ring signal.
To compose a ring signal
1. Scroll to Settings , Y E S , EditMelody , Y E S .
2. Press C L R to clear the display.
3. Use the keypad to enter notes.
The keypad now works as a keyboard (see figure in margin):
•
Press and hold a key to enter a long note.
• Press 0 to raise the note one octave.
4. To listen to your melody, press Y E S .
Press Y E S again to save it or press N O to continue editing.
You can reset some settings to their default values. If you do so, the
following settings are affected:
•
all settings in the Settings menu, except your own ring signal
melody,
• the ring signal volume,
• the earpiece volume and the handsfree speaker volume,
• the alarm function in the Set alarm menu is turned off,
• the Area Info in the Mail menu is turned off.
RING SIGNAL TYPE
YOUR OWN RING SIGNAL
RESET
Settings
< Ring type >
(Mix)
Ring type
< Mix >
Ring type
< Line 1 >
(Mix)
B