Elation Professional CMY Zoom 250 - Manual (Page 27)

CMY ZOOM 250 ™
©Elation Professional® Los Angeles, Ca. 90058 - CMY ZOOM 250™ - -
2. Tap the UP button until “DISP” is displayed.
3. Press MODE/ENTER, the display will show VALU”.
4. Tap the UP button until ”FLIP” is displayed and tap the MODE/ENTER button.
4. Press the UP button to select ON to activate this function, or OFF to deactivate
this function.
5. Press MODE/ENTER to confirm.
6. Press EXIT to return to the main menu.
9. SPEC MAIN MENU -
SPOT - With this function you can adjust the lamp via the control board. The shutter
opens and the lamp can be adjusted. In this mode, the device will not react to any control
signal.
1. Access the main menu.
2. Tap the UP button until ADJU is displayed, press ENTER.
3. Tap the UP button until LADJ is displayed, press ENTER.
4. The display will show ON/OFF .
5. Press the UP button to select ON to activate this function,or OFF to
deactivate this function.
6. Press ENTER to confirm.
7. Press EXIT/DN to return to the main menu.
DFSE - With this function you can restore the factory settings of the device. All settings
will be set back to the default values. Any edited scenes will be lost. When restoring the
factory settings the unit must be set to the address that the unit was in when you started
editing. When you exit this function, the unit will begin to reload data.
1. Access the main menu.
2. Tap the UP button until SPEC is displayed, press MODE/ENTER.
3. Tap the UP button until DFSE is displayed, press MODE/ENTER.
4. The display will show ON/OFF .
5. Press the UP button to display ON to activate this function, or OFF to