Elation Professional CMY Zoom 250 - Manual (Page 22)

CMY ZOOM 250 ™
©Elation Professional® Los Angeles, Ca. 90058 - CMY ZOOM 250™ - -
On-Board System Menu. The CMY ZOOM 250. comes with an easy to navigate system
menu. This next section will detail the functions of each command in the system menu.
Enter Button - To access the main menu locate the MODE/ENTER button on the front of
the unit. Press this button to activate the system menu. Tap the UP button until you reach
function you wish to change. When you reach the function you wish to change tap the
MODE/ENTER button . When a function is selected the menu will begin to .ash, use the UP
button to change the function. Once your changes are made tap the MODE/ENTER button
again to lock the change in the system. To exit without making any changes tap the EXIT
button.
1. Setting/Changing the DMX Address
After applying power to the CMY ZOOM 250™ the LED will display the fixture’s current
DMX address immediately after the reset sequence. If the fixture is not receiving a
DMX signal the display will flash continuously.
To set or adjust a DMX address, please follow the procedure below:
1. Switch on the CMY ZOOM 250™ and wait for the fixture reset process to finished.
2. Press the Mode button to access the main menu. Toggle through the menu by
pressing the Up and Down buttons until the display shows A001 . Tap the enter
button to make changes to the address, the current three digit address will
immediately begin to flash.
3. While the current three-digit address is flashing, use the Up and Down buttons to
select adjust the address. Lock your new address into the unit’s memory by
pressing the Enter button. After the new address has been successfully stored into
the fixture’s memory the LED will briefly readout
PASS .
The DMX address is non-destructible and will remain in the fixture’s memory even
when the power has been switched off. Memory is backed-up and retained by an
internal power source with a five year shelf life.
2. TEST MAIN MENU