Sealey TP955 User Manual
Page 4
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
ImpORTANT: no liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORmATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
01284 757500
01284 703534
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park
,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
Web
Original Language Version
The problem
The Cause
The Solution
Motor not turning
no power
Lift the on/off switch up to the 'on' position
Circuit breaker has tripped
Re-set circuit breaker.
Check that electrical connections are correct
Fuses burnt out
Replace fuse in plug and/or supply panel
Motor faulty / jammed
Inspect motor. Retern to authorised repair
agent if necessary
Motor will not start with nozzel closed / off
Insufficient voltage
Check that voltage is not more than 5%
below the nominal requirment
Low or no flow
Excessive suction pressure
Lower the height of the pump in respect to
the tank and / or increase the diameter of the
suction tube
Suction tube resting on bottom of tank
Raise suction tube
Low level in tank
Refill the tank
Air entering the suction tube or in the pump
Check all piping connections and the level of
fuel in the tank
Low rotation speed of motor
Check and adjust the motor voltage or use
cable with a larger cross section
Check valve blocked
Clean or replace
Tank filler clogged
Clean or replace the filter
Pump filter clogged
Clean or replace filter
Fluid leaks
Check all connections and the condition of
rubber tubes
Meter chamber obstructed
Clean the meter chamber
Meter not accurate enough
Air in the suction line
Check all seals and connections
Measuring chamber dirty
Clean the meter measuring chamber
TP955.V2 Issue: 2 - 23/08/10